Reel retrieve change - XLB

1. Release the brake (pic 1)
2. Remove the spool release cap (pic 2)
3. With a cross point screwdriver remove screw and the end dish. (pic 3)
4. Pull out the bearing holder (pic 4)
5. Inside this there is a one-way bearing. Shake it out, turn it over and put it back again. (pic 5)
6. Put the bearing holder on again. XLB 3(pic 6)
7. Place the end dish on the shaft end and secure it with the screw. (pic 7)
8. Put the spool back and make sure that the cams on the backside of the disc engages the slot in the draw bar. (pic 8)
9. Put back the spool release cap. (pic 9)